Panasonic KX-TG6461E Operating Instructions Manual page 42

TG6461E(e).book Page 42 Monday, March 16, 2009 8:50 AM
Useful Information
Programmable settings
Problem
I have changed the display
language to a language I cannot
read.
While programming, the unit starts
to ring.
While programming, the display
returns to standby mode.
I cannot register a handset to a
base unit.
I cannot remember the PIN.
Battery recharge
Problem
The handset beeps and/or )
flashes.
I fully charged the batteries, but )
still flashes.
I fully charged the batteries, but
the operating time seems to be
shorter.
The handset display is blank.
Making/answering calls, intercom
Problem
w is flashing.
42
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Cause/solution
L Change the display language (page 12).
L A call is being received. Answer the call and start again after
hanging up.
L A call matching an entry in the call barred list is being received.
Wait and try again later.
L The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 26).
L You entered the wrong PIN. If you forget your PIN, see "I cannot
remember the PIN." (page 42).
L Place the handset and the base unit away from other electrical
appliances.
L Change the PIN using the following method.
Handset:
1
8 (middle soft key)
2
{V}/{^}: "Base Unit Setup" i M
3
{V}/{^}: "Base Unit PIN" i M
4
{*}{7}{0}{0}{0}
5
Enter the new 4-digit base unit PIN. i M i {ih}
Cause/solution
L Battery charge is low. Fully charge the batteries (page 8).
L Clean the charge contacts and charge again (page 9).
L It is time to replace the batteries (page 8).
L Clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.
L The handset is not turned on. Turn the power on (page 12).
Cause/solution
L The handset is too far from the base unit. Move closer.
L The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
L You are using the base unit or handset in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
L The handset is not registered to the base unit. Register it (page
25).