Opening And Closing The Lcd Panel; Ejecting A Disc; Ejecting An Sd; Setting The Clock - Pioneer AVH-P5350DVD Owner's Manual

Basic operations
Displaying the menu.
Refer to Introduction of menu opera-
tions on page 43.
Displaying still images as a slide
show when listening to another
source.
Viewing slide shows.
Refer to Introduction of still image
playback operations on page 21.
Returning to the previous display.
Returning to the previous list/cate-
gory (the folder/category one level
higher.)
Opening and closing the
LCD panel
The LCD panel will open or close automatically
when the ignition switch is turned on or off.
You can turn off the automatic close/open
function.
! Do not close the LCD panel by force with
your hands. That will cause a malfunction.
! The automatic close/open function will op-
erate the display as follows.
— When the ignition switch is turned OFF
while the LCD panel is opened, the LCD
panel will close after six seconds.
— When the ignition switch is turned ON
again (or turned to ACC), the LCD panel
will open automatically.
— Removing or attaching the front panel
will automatically close or open the LCD
panel. (Refer to Protecting your unit from
theft on page 6.)
! When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press OPEN/CLOSE to open the
LCD panel.
! When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
CAUTION
Keep hands and fingers clear of the unit when
opening, closing, or adjusting the LCD panel. Be
especially cautious of children's hands and fin-
gers.
% Press OPEN/CLOSE to open the LCD
panel.
# To close the LCD panel, press OPEN/CLOSE
again.
Turning the LCD panel horizontally
When the LCD panel is upright and hinders
the operation of the air conditioner, the panel
can be turned horizontally temporarily.
% Press and hold OPEN/CLOSE to turn the
LCD panel horizontally.
# To return to the original position, press and
hold OPEN/CLOSE again.
# The LCD panel returns to the original position
automatically, indicated with a beeping sound 10
seconds after operation.

Ejecting a disc

1 Press h (eject).
2 Eject a disc.

Ejecting an SD

1 Remove the front panel.
Refer to Removing the front panel on page 7.
2 Push an SD.
3 Eject an SD.

Setting the clock

1 Switch to Clock Adjustment display.
Refer to Basic operations of this unit on page
11.
2 Select the item to set.
3 Touch a or b to set the correct date
and time.
Section
04
13
En