Panasonic KX-TG8280FX Operating Instructions Manual page 53

TG8280FX(e).book Page 53 Tuesday, September 11, 2007 1:52 PM
Problem Cause & solution
Noise is heard during a L You are using the handset or base unit in an area with
call.
The handset/base unit L Disconnect the base unit AC adaptor and turn off the
stops working while
being used.
The handset beeps L Fully charge the batteries (page 13).
intermittently and/or
3 flashes.
I fully charged the L Clean the charge contacts and charge again
batteries, but 3 still
flashes.
L It is time to replace the batteries (page 12).
I fully charged the L Wipe the battery ends (S, T) and the unit contacts
batteries, but the
operating time seems
to be short.
Caller information is not L You need to subscribe to Caller ID service. Consult
displayed.
L Your unit is connected to a telephone line with DSL
I cannot register a L The maximum number of handsets (6) are already
handset to a base unit.
L You entered the wrong PIN. If you forget your PIN,
L Place the handset and the base unit away from other
I do not know how to L There are unviewed missed calls remaining. View
erase y (Missed call)
from the display.
I cannot establish a L A conference call cannot be established in the
conference call.
high electrical interference. Place the handset and
base unit away from interference sources, such as
antennas and mobile phones.
handset. Reconnect the base unit AC adaptor, turn on
the handset and try again.
(page 13).
with a dry cloth.
your service provider/telephone company for details.
service (page 55).
registered to the base unit. Cancel unused handset
registrations from the base unit (page 43).
consult your nearest Panasonic service centre.
electrical appliances.
them using the following method.
1
" (middle soft key) i j i #
2
Press {V} to search from the most recent call, or
press {^} to search from the oldest call.
following instances;
– the base unit's settings or the answering system is
currently in use
– a conference call has already been established on
another line
– an intercom call is currently being made by another
user
Wait for the other user to finish.
Useful Information
53