Panasonic KX-TG8280FX Operating Instructions Manual page 52

TG8280FX(e).book Page 52 Tuesday, September 11, 2007 1:52 PM
Useful Information
Problem
The handset will not
turn on.
I have changed the
display language to a
language I cannot read.
I cannot make or
receive calls.
The unit does not ring.
The batteries should be
charging but the battery
icon does not change.
A busy tone is heard
when {C} is pressed.
Static is heard, sound
cuts in and out.
Interference from other
electrical units.
52
Cause & solution
L Make sure that the batteries are installed correctly
(page 12).
L Fully charge the batteries (page 13).
L Clean the charge contacts and charge again
(page 13).
L Change the display language (page 14).
L The base unit AC adaptor or telephone line cord is not
connected. Check the connections.
L If you are using a splitter to connect the unit, remove
the splitter and connect the unit to the wall socket
directly. If the unit operates properly, check the
splitter.
L Disconnect the base unit from the telephone line and
connect the line to a known working telephone. If the
working telephone operates properly, contact our
service personnel to have the unit repaired. If the
working telephone does not operate properly, contact
your service provider/telephone company.
L The dialling mode setting is incorrect. Set to "Tone"
or "Pulse" as needed (page 15).
L You dialled a call restricted number (page 31).
L The key lock feature is turned on. Turn it off (page 20).
L The ringer volume is turned off. Adjust the ringer
volume (page 24, 29).
L The night mode feature is turned on. Turn it off
(page 28).
L Clean the charge contacts and charge again
(page 13).
L The handset is too far from the base unit. Move closer
and try again.
L Another handset is in use or the answering system is
being used. Wait and try again later.
L Place the handset and the base unit away from other
electrical appliances.
L Move closer to the base unit.
L Your unit is connected to a telephone line with DSL
service (page 55).