Display Language; Registering A Handset To A Base Unit; For Your Safety - Panasonic KX-TGA410 Installation Manual

TGA410(e).fm Page 4 Monday, November 8, 2010 4:33 PM

Registering a handset to a base unit

1
Base unit:
Press and hold {LOCATOR} for about 5 seconds until the registration
tone sounds.
L If all registered handsets start ringing, press {LOCATOR} again to
stop, then repeat this step.
2
Handset:
Place the handset on the base unit or charger, then wait until a long
beep sounds and w is displayed.
Note:
L If an error tone sounds, or if _ is displayed, register the handset
according to the base unit's operating instructions.

Display language

1
{MENU} (11)
2
{r}: Select the desired setting.
3
{SAVE} s {OFF}

For your safety

To prevent severe injury and loss of life/property, read this section carefully before
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
L Completely insert the AC adaptor/power plug into the power outlet. Failure to do
so may cause electric shock and/or excessive heat resulting in a fire.
L Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a fire.
L Unplug the product from power outlets if it emits smoke, an abnormal smell, or
makes an unusual noise. These conditions can cause fire or electric shock.
Confirm that smoke has stopped emitting and contact the Panasonic Call Center
at 1-800-211- PANA (1-800-211-7262).
4
For assistance, please visit http://www.panasonic.com/help