Panasonic Viera TX-P42UT50E Operating Instructions Manual page 84

Reduce unnecessary power consumption in Standby [Standby Power Save]
Set Standby Power Save [On] in the Setup Menu to use this function
The power consumption in Standby mode of the connected equipment is controlled higher or lower in synchronisation
with the TV on / off state to reduce the consumption.
When the TV is set to Standby mode, the connected equipment is automatically set to Standby and the power
consumption of the connected equipment is automatically minimised.
When the TV is turned on, the connected equipment is still in Standby mode, but the power consumption is increased
to make startup time fast.
This function is effective if the connected equipment can change the power consumption in Standby mode and is set
to higher consumption.
This function works when [Power off Link] is set to [On].
Auto standby for unnecessary equipment [Intelligent Auto Standby]
Set Intelligent Auto Standby [On (With reminder)] or [On (No reminder)] in the Setup Menu to use this function
[Intelligent Auto Standby] (p. 43)
When the TV is on, non-watched or non-used connected equipment goes into Standby mode automatically to reduce
the power consumption. For example, when the input mode is switched from HDMI or when Speaker Selection is
changed to [TV] (except for watching a disc).
If you select [On (With reminder)], the on-screen message will be displayed before the connected equipment turns to
standby.
This function may not work properly depending on the connected equipment. If required, set to [Off].
Direct TV Recording
Records the current programme in the DIGA Recorder immediately.
If you connect a variety of recorders including other manufacturers' recorders at the same time, connect the DIGA
Recorder to the TV's lower HDMI terminal number. For example, if you use HDMI1 and HDMI2 for two recorders,
connect the DIGA Recorder to HDMI1.
If you cannot operate, check the settings and the equipment.
"Summary of Q-Link and VIERA Link features" (p. 80, 81), "Preparations" (p. 83)
To record the programme which DIGA Recorder does not support, SCART connection is required and the programme
is recorded by Q-Link function (p. 82).
Depending on the programme, SCART connection may be required to record.
You can change channel or turn the TV off while the recorder is recording from its own tuner.
You can not change channel while the recorder is recording from the TV tuner.
Display [VIERA TOOLS] and select [VIERA Link]
1
Select [Direct TV Rec] and start recording
2
VIERA Link Menu
Pause Live TV
Direct TV Rec
VIERA Link Control
Speaker Selection
To stop recording
Select [Stop] in [Direct TV Rec]
VIERA Link Menu
Pause Live TV
Direct TV Rec
VIERA Link Control
Speaker Selection
You can also stop recording directly.
Unlock the tuner
84
- What you see is What you record
VIERA Link
Start
Start
Recorder
Home Cinema
Start
Stop
Recorder
Home Cinema
Tuner Locked
Press EXIT to unlock and stop recording
[Direct TV Rec]
select
access / start
select
access / stop
[Standby Power Save] (p. 42)
select
access
You can also start recording directly
when the code of the remote control is
"73" (p. 30).