Panasonic Viera TX-P42UT50E Operating Instructions Manual page 34

To change 3D format manually
When the image is not changed properly using [3D], [2D] or [2D 3D] mode, use this manual setting.
During the above operation
(red)
[Original]:
Displays the source image as it is.
Use to identify the format type of the source image.
"Table of images that can be seen for each [3D Mode Selection (Manual)] and the source image format"
(see below)
[Frame Sequential - 3D] / [Frame Sequential - 2D] / [Side by Side - 3D] / [Side by Side - 2D] /
[Top and Bottom - 3D] / [Top and Bottom - 2D]:
Displays the mode you select.
Not valid on Analogue and AV mode
[2D 3D]:
Converts 2D images into 3D.
Please note the 3D images appear slightly different from the originals.
Using this function for profit-making purposes, or publically showing images converted from 2D to 3D in places
such as shops or hotels etc. may infringe on the rights of the copyright holder protected under copyright law.
Table of images that can be seen for each [3D Mode Selection (Manual)] and the source image format
If the picture appears to be abnormal, refer to the table below to choose the correct 3D mode.
[3D Mode Selection]
Source
image format
Frame Sequential
Side by Side (Full)
Side by Side
Top and Bottom
Normal format (2D)
1: When selecting [Frame Sequential - 2D], [Side by Side - 2D] or [Top and Bottom - 2D], the images will be displayed
without 3D effect.
Depending on the player or broadcasts, the image may be different from the above illustrations.
34
Select the mode
3D Mode Selection (Manual)
Original
Frame Sequential - 3D
Frame Sequential - 2D
Side by Side - 3D
Side by Side - 2D
Top and Bottom - 3D
Top and Bottom - 2D
2D 3D
[Frame
[Original] Sequential
- 3D]
Normal 3D
select
set
[Side by Side [Top and
- 3D] Bottom - 3D]
1
Normal 3D
1
Normal 3D
1
Normal 3D
[2D 3D]
1
Normal 3D