Silvercrest KH 1143 Operating Instructions Manual page 8

If you have selected the setting "Knife with smooth edge"
• Always sharpen knives with a smooth edge on both sides – for this, left
and right side sharpening guides are available.
• In the left guide hold the knife inclined to the left, and in the right guide
inclined to the right, whilst drawing the blade through.
If you have selected the setting "Knife with serrated edge"
• Sharpen these only on the side with the serration – the draw through di-
rection for the knife is dependant on which side of the blade this is on.
• In general, serrated blades can only be sharpened up to a point. Knifes
with a fine sawtoothing (e.g. table knives) do not require sharpening.
If you have selected the setting "Scissor sharpening"
• Sharpen both scissor blades one after the other. For this, open the scissors
out and draw both blades, one after the other, through the guide.
Should you wish to grind a slot-screwdriver
• This is possible in every position of the function cap
width, insert the screwdriver through one of the two grinding openings
on the front of the function cap (see fold-out side). The end face of the
screwdriver will now be ground level and flat.
Certain edges can possibly be more easily sharpened directly on the grind-
t
stone , without the function cap: For these cases, the function cap is re-
movable:
• Turn the function cap
You can now take off the function cap.
• To replace the function cap
again at the top. You can now push the cap on and secure it by turning
it to the left or right.
y
until the arrow
y
, hold it so that the arrow
- 8 -
q
w
e
:
r
flat:
y
. Appropriate to its
is at the top.
:
:
r
is once