User Information; Specifications - Panasonic TX-25LK1F Operating Instructions Manual

USER INFORMATION

H Service
Before requesting service look through the Troubleshooting . To
obtain service get in touch with your dealer and tell them your
television model type and serial number (to be found on the rear
panel).
H TV games/Home computers
Frequent use of the games console or computer may cause
"shadows" on the screen. This can be avoided if you meet the
following requirements:
` Reduce brightness and contrast to minimum;
` Do not use your television continuously with the game
console and computer
` Remember that this type of screen damage is not an
operation defect and is not covered by the Panasonic
warranty.

SPECIFICATIONS

Model
Power source
Power consumption
Power used in Standby mode
Screen
51 cm diagonal
Sound
(music)
Dimensions
Weight (kg)
TV systems/zones TV systems/zones
Number of programme positions
Aerial input --- rear
Headphones output --- front
AV connector --- rear
AV connector --- front
The specifications may be subject to change without notice. Weight and dimensions are approximate.
2001CX
20
H Last settings saved
Some functions allow the last settings to save , i.e. the following
settings will be activated when you turn on the television again:
Programme positions
Q-Link
Volume correction (+AV)
Volume
Sound type: music/speech
Bass
Treble
Standby mode
Country
Last viewed programme
H Automatic switch---off (Sleep Function)
If the television remains switched on when the station ends
transmission, the television will automatically be put in standby
mode after 30 minutes. This function does not operate in the AV
mode.
TX-28LK1F
76 W
66 cm
2 x 5W RMS (2 x 10W MPO), impedance 8Ω
H 571 mm
W 778 mm
D 478 mm
31,5 kg
PAL B/G, PAL H, PAL-60, SECAM B/G, SECAM L/L'
VHF E2 - E12
VHF A - H (ITALY)
CATV (S01 S05) CATV (S01 - S05)
CATV S11 - S20 (U1 - U10)
M.NTSC playback from VCR NTSC 4.43 MHz
NTSC playback (via AV input) from VCR NTSC
AV1--- 21---pin connector --- AV input/output, RGB input, Q---Link
Front AV --- RCA stereo sound signal input, 1 x RCA video signal input
220 - 240 V, 50Hz AC power source
0,9W
VHF H1 - H2 (ITALY)
UHF E21 - E69
CATV S1 - S10 (M1 - M10) CATV S1 S10 (M1 M10)
CATV S21 - S41 (Hyperband)
99 + VCR
UHF / VHF
3.5 mm, impedance 8Ω
Tint
C---A---T---S
Contrast
Sharpness
Brightness
Colour
L/R balance
Status
OSD language
TX-25LK1F
72W
59 cm
522 mm
718 mm
464 mm
26,8 kg