Panasonic SC-BTT282 Operating Instructions Manual page 47

On the unit's display
F99
The unit fails to operate properly. Press [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
[BTT282] HDMI ONLY
Some BD-Video discs can only be output with
HDMI.
NET
While connecting to a network.
No PLAY
There is a viewing restriction on a BD-Video
or DVD-Video. (
No READ
The media is dirty or badly scratched. The
unit cannot play.
PLEASE WAIT
The unit is carrying out internal process. This
is not a malfunction. You cannot operate the
unit while "PLEASE WAIT" is displayed.
REMOVE
The USB device is drawing too much power.
Remove the USB device.
SET
(" " stands for a number.)
The remote control and main unit are using
different codes. Change the code on the
remote control.
Press and hold [OK]
and the indicated
number button at the
same time for more
than 5 seconds.
U59
The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit.
39)
H or F
(" " stands for a number.)
Check and correct the speaker cable
connections.
There is something unusual.
Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1 Disconnect the plug from the household
mains socket, wait a few seconds, then
reconnect it.
2 Press [Í/I] to turn the unit on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
IPOD OVER CURRENT ERROR
The iPod/iPhone is drawing too much power.
Remove the iPod/iPhone, and turn the unit off
and on again.
START
The system is being restarted during the
firmware update. Please do not turn off the unit.
UPD /
(" " stands for a number.)
The firmware is being updated. Please do not
turn off the unit.
FINISH
The firmware update is complete.
NOT CONDITIONAL
The requested operation cannot be
conducted.
SET OK
The stations are set, and the radio tunes to
the last preset station.
ERROR
Automatic presetting is unsuccessful. Preset
the stations manually.
TUNED/STEREO
Stereo broadcasting or stereo sound is
selected.
TUNED
Monaural broadcasting or monaural sound is
selected.
47
VQT3Z99