2. Plastic base plate
3. Hex wrench
1. Hex wrench
2. Rip fence (Guide rule)
1. Threaded knob
2. Circular guide
3. Plastic cover
Plastic base plate (optional accessory)
Use the plastic base plate when cutting decorative veneers, plastics, etc. It
protects sensitive surfaces from damage. To replace the base plate, remove
the four screws.
Rip fence (optional accessory)
When cutting widths of under 150 mm repeatedly, use of the rip fence (guide
rule) will assure fast, clean, straight cuts. To install it, loosen the bolt on the
front of the base. Slip in the rip fence and secure the bolt.
Circular guide (optional accessory)
Use of the circular guide insures clean, smooth cutting of circles under
200 mm in radius. Insert the pin through the center hole and secure it with the
threaded knob. Move the base of the tool forward fully. Then install the circular
guide on the base in the same manner as the rip fence (guide rule).
Plastic cover and vacuum head (optional accessory)
The vacuum head is recommended to perform clean cutting operations. Install
the plastic cover on the tool by fitting it into the notches in the tool.