All electrical work should be carried
out by a suitably qualified and
competent person, in strict
accordance with current local and
national safety regulations (BS 7671
in the UK).
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
Ensure power is not supplied to the
appliance until after installation work
has been carried out.
Do not connect the appliance to the
mains electricity supply via an
extension lead. These do not
guarantee the required safety of the
Please ensure that the connection data
quoted on the data plate match the
household mains supply.
Connection should be made via a fused
plug and switched socket which
complies with national and local safety
regulations and the on/off switch should
be easily accessible.
For extra safety it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA.
When switched off there must be an
all-pole contact gap of 3 mm in the
isolator switch (including switch, fuses
This appliance is supplied for
connection to a single phase 230-240 V
50 Hz supply with a 3-core cable.
The wires in the mains lead are
coloured in accordance with the
Green/yellow = earth
Blue = neutral
Brown = live
THIS APPLIANCE MUST BE
Non-rewireable plugs BS 1363
The fuse cover must be refitted when
changing the fuse, and if the fuse cover
is lost, the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is
embossed in words on the base of the
plug (as applicable to the design of
Replacement fuses should be ASTA
approved to BS 1362 and have the
correct rating. Replacement fuses and
fuse covers may be purchased from
your local electrical supplier.