CT 400 P installation instructions
A protective shelf must be fitted imme-
diately below the switching unit to
ensure that the underside of the
appliance cannot be accessed or
touched after it has been built in.
A gap of 10 mm must be maintained
between the shelf and the rear wall.
Do not use any sealant unless
expressly instructed to do so. The
sealing strip under the edge of the top
part of the tepan provides a sufficient
seal for the worktop.
Do not use sealant between the
frame of the top part of the tepan
and the worktop.
This could cause difficulties if the
tepan ever needs to be taken out for
servicing and possibly result in
damage to the frame or the worktop.