Download  Print this page

Drilling Holes In The Furniture Front Panel For The Switching Unit - Miele CT 400 MP Operating And Installation Instructions

Built-in and mobile tepan
Hide thumbs

Advertisement

CT 400 P installation instructions
Drilling holes in the furniture
front panel for the switching
unit
Use the drilling template supplied e to
drill the holes for the switching unit in
the furniture front panel.
Drill 3 holes through the front panel,
working from the front as follows:
a for the switching unit spindle
b for the yellow indicator light
c for the red indicator light
To secure the switching unit, make 4
pilot holes d in the front panel
working from the rear.
24
Important:
Humidity may cause variation in the
size of the drilling template.
Please check the dimensions
before drilling.
On a 40 mm thick worktop place the
drilling template e so that it is flush
with the underside of the worktop (see
illustration).
The gap between the underside of the
worktop and front panel should be
5 mm.

Advertisement

Table of Contents
loading

  Related Manuals for Miele CT 400 MP

This manual is also suitable for:

Ct 400 p