Troubleshooting; Messages On The Unit's Display - Panasonic Diga DMR-PWT500 Operating Instructions Manual

Messages on the unit's display

Troubl
eshooti
ng
The following messages or service numbers appear
on the unit's display when something unusual is
detected during startup and use.
SET
("∑" stands for a number.)
The remote control and main unit are using
different codes. Change the code on the remote
control.
Unit's display
GUIDE
TV Guide data is being downloaded.
FINISH
The software (firmware) update is complete.
( 87)
HARD ERR
If there is no change after turning the unit on and
off, consult the dealer where the unit was
purchased.
NoREAD
The disc is dirty or badly scratched. The unit
cannot play. (
This message may appear when the lens cleaner
has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to eject
the disc. ( 22)
PLEASE WAIT
Displayed when the unit is started and turned off.
There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. This process
restores the unit to normal operation. The unit is
not broken. Wait until the message disappears.
PROG FULL
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
92
VQT3C81
Press and hold [OK] and the
indicated number button at
the same time for more than
5 seconds. ( 84)
21)
37)
REMOVE
The USB device is drawing too much power.
Remove the USB device.
START
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. ( 87)
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
UNSUPPORT
You have inserted a disc the unit cannot play.
( 18)
You tried to operate with a non-compatible media.
UPD /
("∑" stands for a number.)
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. ( 87)
U59
The unit is hot.
The unit switches to standby for safety reasons.
Wait for about 30 minutes until the message
disappears.
Select a position with good ventilation when
installing the unit. Do not block the cooling fan on
the rear of the unit.
U61
(When a disc is not inserted) Displays when a
malfunction has occurred. This is displayed when
the unit is in the recovery process to return to
normal operation. Once the display clears you can
use the unit again.
If it remains displayed, consult the dealer where
the unit was purchased.
U76
HDMI cannot be output because it is connected to
a model that does not support copyright protection.
87)