MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
Front View
q
POWER
ON
OFF
q Power On/Off Switch (POWER ON/OFF)
This switch is used to turn the camera drive
unit and connected camera on and off. The
indicator lights up when the camera drive
unit is switched on.
When turns this switch off, the power supply
does not interrupt. In such a case, discon-
nect the AC cord or turn the circuit breaker
off.
w Camera Input Connector (CAMERA IN)
This connector receives colour or B/W com-
posite video signal from the camera. It also
supplies DC power and vertical drive pulses
for synchronizing signals to the camera and
receive video and audio signals from the
camera.
e Video Output Connector (VIDEO OUT)
Video signals from the camera is output from
this connector for input to outboard devices.
5
Rear View
w
e
r
CAMERA
VIDEO
AUDIO
IN
OUT
OUT
r Audio Output Connector (AUDIO OUT)
Audio signal from the camera is output from
this connector for input to the outboard
devices (if an applicable camera is connect-
ed).
t VD/SYNC Input Connector (VD/SYNC IN)
The VD (Vertical Drive) pulse or VS (Video
Sync) signal is supplied to this connector for
synchronizing the system.
y VD/SYNC Output Connector (VD/SYNC
OUT)
The VD (Vertical Drive) pulse or VS (Video
Sync) signal is output from this connector for
synchronizing other system components.
u
Signal Ground Terminal (SIGNAL GND)
i
AC Cord
t
y u
SIGNAL
GND
VD/SYNC
VD/SYNC
IN
OUT
(4V[p-p]75 )
i
Need help?
Do you have a question about the WV-PS15 and is the answer not in the manual?
Questions and answers