Misfeed In The Saddle Stitch Finisher - Sharp MX-M350U Operation Manual

SADDLE STITCH FINISHER

Misfeed in the saddle stitch finisher

When a misfeed occurs in the saddle stitch finisher, remove the misfed paper following the procedure below.
1 Press the detach button and separate the
saddle stitch finisher from the machine.
CAUTION
The saddle stitch finisher and the machine are
connected at the rear. Exercise caution when pulling
them apart.
Remove any misfed paper from the
2
machine.
3 If there was no misfed paper in step 2, pull
roller rotating knob B on the punch unit
toward you and rotate it. (Only when an
optional punch unit is installed.)
Roller rotating
knob B
4 Open the top cover.
3-22
Rotating roller rotating
knob B releases the
caught paper.
5 Remove the misfed paper.
6 Close the top cover.
7 Remove any misfed paper from the stapler
compiler.
8 Open the cover of the saddle stitch
section.
Remove the misfed paper.
9
Remove the paper
gently, taking care not to
tear it.
Remove the paper
gently, taking care not to
tear it.
Remove the paper
gently, taking care not to
tear it.