Panasonic Lumix DMC-FT25 Operating Instructions Manual page 143

Digital camera
Table of Contents

Advertisement

[Please turn camera off and then on again]/[System Error]
This message will be displayed when the lens did not operate properly.
> Turn the camera off and on. If the message persists, contact the dealer or Panasonic.
[Memory Card Error]/[Memory card parameter error]/[This memory card cannot be
used]
> Use a card compatible with this unit.
SD Memory Card (8 MB to 2 GB)
SDHC Memory Card (4 GB to 32 GB)
SDXC Memory Card (48 GB, 64 GB)
[Insert SD card again]/[Try another card]
An error has occurred accessing the card.
> Insert the card again.
> Insert a different card.
[Read Error/Write Error
Please check the card]
It has failed to read or write data.
> Remove the card after turning this unit off. Insert the card again, turn this unit on, and try to
read or write the data again.
The card may be broken.
> Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the card]
Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures.
In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P50).
Depending on the type of the card, motion picture recording may stop in the middle.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
> Format the card after saving necessary data on a PC etc.
> Insert a different card.
Others
(P22)
- 143 -
(P50)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents