Installations And Connections - Panasonic BM-ET500E Operating Instructions Manual

Iris camera
Table of Contents

Advertisement

INSTALLATIONS AND CONNECTIONS

WARNING
The installation described in these figures should be made
by qualified service personnel or trained system installers.
Cautions:
• This system must be installed within the protected
promise
in
accordance
Electrotechnical Commission, and the local authorities
having jurisdiction.
• Attach this unit to a flat wall with the supplied mounting
bracket. After the installation, secure the unit to prevent
dropping.
The unit can be mounted over the wall as described.
1. Attach the anchor into the wall, and then attach the sup-
plied mounting bracket to the anchor.
(Refer to the figure in p.12.)
The anchor bolt should meet the standards shown in
the illustration.
10 mm (2/5 in.) or less
Mounting bracket
2 mm (2/25 in.) (D)
9
with
the
International
2. Remove the shipping lock as follows:
Locked
1
Belt
(1) Remove the screw.
3
Unlocked
(3) Bend the belt and secure it with the screw.
• Take care not to drop the screw inside the unit.
• You can use an M3 screw if you have lost this screw.
3. Remove the numeric keyboard.
You can remove the keys by taking off the two tamper-
proof screws (with the supplied screw driver tool) and
lifting up the keyboard. The control cable should also
be removed.
Remove the screws.
2
(2) Insert the belt until it hits
to the stop.

Advertisement

Table of Contents
loading

Table of Contents