Troubleshooting - Panasonic BM-ET500E Operating Instructions Manual

TROUBLESHOOTING

Check to see the following before request for repair.
If a trouble cannot be corrected even after checking and trying remedy, contact your dealer.
Problem
System does not power up.
"REJECT" is lighting.
The status indicator does not light up.
The buzzer does not sound.
17
Check item
The power of the control unit may be
turned off. (The control unit supply the
power to the unit.)
Third party external power may be off.
This unit may be disconnected from the
control unit.
Your iris data, ID, or password may not
have been registered.
Your ID or password may be wrong.
The front panel may have dust or be
damaged.
The coaxial cable may not be connected
between the unit's VIDEO OUT and the
control unit's iris camera connector
(CAMERA 1 to 3).
The power of the control unit may be
turned off. (The control unit supply the
power to the unit.)
Third party external power may be off.
This unit may be disconnected from the
control unit.
The buzzer level may be too low to be
heard.
Remedy
Confirm if the power of the control unit
is turned on. (Refer to the control unit's
operating instructions.)
Refer to the dealer or service person-
nel.
Refer to the system administrator.
Remove the dust from the front panel.
If the panel has been damaged,
replace it with a new one.
(Refer to p.13.)
Confirm the connection. (Refer to p.10.)
Confirm if the power of the control unit
is turned on. (Refer to the control unit's
operating instructions.)
Refer to the dealer or service person-
nel.
Adjust the buzzer level. (Refer to p.13.)