Preparation Before Operation
Remote controller
Setting the batteries
Address switch
1
Press
with a finger and slide the
back cover to take it off.
2
Set two alkaline dry batteries (LR03).
3
Set the back cover as before.
•
This will cause the figures on the display to flash. Set
the clock at this point.
•
The address switch is used when two indoor units are to
be installed in a single room.
•
If there is only one indoor unit in the room, it must be set
to "1".
•
To install two units in a single room, consult the shop
where you bought the air conditioner.
ATTENTION
About batteries
•
Always replace two batteries at the same time. Replace
them with new ones of an identical type.
•
Do not use manganese dry batteries since their use may
cause a malfunction.
•
If you are not going to use the air conditioner for a long
period, take out all the batteries.
•
Batteries should last for about a year under normal
conditions. When you find the displays unclear and
signal communication often failing, replace them with
new ones.
•
Batteries
may
be
recommended date of consumption printed on them, if
the air conditioner was manufactured many months ago.
•
Never try to recharge the batteries.
6
Position
and
correctly!
2
1
exhausted
even
before
Operating the remote controller
•
To use the remote controller, aim the transmitter at the indoor
unit. If there is anything to block signals between the unit and
the remote controller, such as a curtain, the unit will not
operate.
•
Do not drop the remote controller. Do not get it wet.
•
The maximum distance for communication is about 7 m.
3
To fix the remote controller holder
on the wall (option)
1
Choose a place from where the signals
reach the unit.
2
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3
Fit the claw of the holder into the bottom of
the remote controller, and push the remote
controller onto the wall.
Push.
Set.
•
To remove, pull it upwards.
ATTENTION
About the remote controller
•
Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce
the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-
starter-type fluorescent lamp (such as inverter-type
lamps) is in the room. Consult the shop if that is the
the
case.
•
If the remote control signals happen to operate another
appliance, move that appliance to somewhere else, or
consult the shop.
Receiver
Remote
controller
holder