Panasonic CS-E12HKEW-3 Operating Instructions Manual page 7

TO SELECT FAN SPEED
(5 OPTIONS)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
TO ADJUST VERTICAL AIRFLOW
DIRECTION (5 OPTIONS)
• Keeps the room ventilated.
• If AUTO is set, the louvers swing up/down
automatically.
• In heat mode, the air blows horizontally for a while,
then starts to blow downwards.
TO ENJOY CLEAN &
FRESH AIR
• Generates negative ions to produce fresh air effect
and attract dust which will then be captured at the
positively charged e-ion fi lters.
TO MONITOR AIR
QUALITY
• Patrol sensor detects air quality.
• When the air quality is unsatisfactory, e-ion operation
will start automatically.
TO ENJOY QUIET
ENVIRONMENT
• This operation reduces airfl ow noise.
TO ACHIEVE
TEMPERATURE QUICKLY
• , , and
in all modes and can be cancelled by pressing the
respective button again.
• and or
selected at the same time.
• and operations could be activated even
when the air-conditioner is turned off. In this condition,
once e-ion indicator is ON, the unit will operate with
AUTO fan speed and air swing. However,
operation could not be activated if other indoor unit is
activating heating operation.
can be activated
and can not be
TO SET THE TIMER TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
Select ON or Set the time.
OFF timer.
• To cancel ON or OFF timer, press
press .
• When ON Timer is set, the unit may start earlier (up
to 35 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
OPTIONAL SETTINGS OPTIONAL SETTINGS
Patrol starts automatically with the unit
switched on with
Press and hold for 5 seconds, then release
to disable or restore this setting.
Press and hold for 5 seconds to dim or
restore the unit's indicator brightness.
Press and hold for approximately 10
seconds to show temperature setting in °C
or °F.
Press and hold for approximately 5 seconds
to show 12-hour (am/pm) or 24-hour time
indication.
Press to restore the remote control's default
setting.
,
Not used in normal operations.
Set the temperature 1°C higher in cool mode or 2°C
lower in heat mode than the desired temperature to
achieve a 10% power saving.
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
TIMER
Confi rm.
or then
.
.
7