Kenwood CM650 series User Manual

CM650
CM660
safety before using for the first
time
●
Never let the cord hang down over
1 Remove all packaging.
the worktop edge - a child could
2 Wash the parts: see 'care and
grab it and pull the machine down.
cleaning'.
Push excess cord inside the back
3. Push excess cord inside the back
of the machine.
of the machine.
●
Always make sure there is water in
4. Run two lots of water through the
the tank before switching on.
machine (without coffee) to clean it
●
Never use a damaged coffee
out. Fill the tank to the top cup
maker. Get it checked or repaired:
mark when you do this. See 'to
See 'service and customer care'.
make coffee'.
key
●
Never put the machine in water or
let the cord or plug get wet.
hotplate
●
Watch out for steam and never
compartment for excess cord
touch the hotplate.
filter door release button
●
This appliance is not intended for
permanent coffee filter (or use a
use by persons (including children)
paper filter instead)
with reduced physical, sensory or
filter holder
mental capabilities, or lack of
filter door
experience and knowledge, unless
on/off switch with indicator light
they have been given supervision
(model CM650 only)
or instruction concerning use of
additional features on the
the appliance by a person
CM660
responsible for their safety.
strength control indicator light
●
Children should be supervised to
strength control button
ensure that they do not play with
auto/on/off indicator light
the appliance.
auto/on/off button
●
Only use the appliance for its
automatic timer light
intended domestic use. Kenwood
automatic timer button
will not accept any liability if the
hour button
appliance is subject to improper
minute button
use, or failure to comply with these
instructions.
to set the clock (model
CM660 only)
before plugging in
(the clock does not have to be set
Make sure your electricity supply is
the same as the one shown on the in order for the coffee maker to
underside of your machine. operate)
1 Plug into the power supply.
Important (UK) only
2 Press the hour and minute buttons
●
The wires in the cord are coloured
until the correct time is shown.
as follows:
Make sure when selecting the hour
Green and Yellow = Earth
that AM or PM is correctly
Blue = Neutral
selected.
Brown = Live.
●
Providing the appliance remains
●
This machine complies with
connected to the power supply the
European Economic Community
clock will keep the correct time, if it
Directive 89/336/EEC.
is unplugged the clock will flash
12:00.
●
to make coffee If you haven't used the machine for
1 Pour water into the tank. The a while, run one lot of water
water must be between the top through it (without coffee) to clean
and bottom cup marks. Then close it out. Fill the tank to the top cup
the lid. mark when you do this.
● ●
Use cold water. We recommend Never put the jug in the
using filtered water from a microwave.
Kenwood Water Filter as it reduces
to use the automatic timer
limescale. Never use warm or fizzy
(model CM660 only)
water.
1 Set the correct time.
●
If you use the jug to fill the tank,
2 Press the automatic timer button
look at the tank marks, not the jug
and at the same time adjust the
marks. They're slightly different to
Hour and Minute buttons to
allow for the fact that some of the
display the time you want the
water gets absorbed by the coffee.
coffee maker to come into
2 Open the filter door by pressing
operation. Make sure that the
the release button and insert the
desired AM or PM is selected.
filter holder.
3 Release the automatic timer
3 Add either a permanent filter or a
button.
paper filter. Add the coffee
4 Press the auto/on/off button once.
(approximately 1 rounded
The automatic timer light will glow.
dessertspoon/7g per cup). Then
●
When the set brewing time is
close the filter door.
reached the coffee maker will
4 Put the jug on the hotplate.
operate, the automatic timer light
5 Plug in and switch on.
will go out and the auto/on/off light
●
Model CM660 press the
will come on.
auto/on/off button twice. The
light will come on.
care & cleaning
6 CM660: to produce stronger
coffee press the strength control
●
Always switch off and unplug
button.
before cleaning.
●
During operation the strength
●
Never put the machine in water or
control indicator light will glow for
let the cord or plug get wet.
approximately 10 minutes.
jug, lid, filter holder,
7 Don't remove the jug until brewing
permanent filter
has finished. The hotplate will keep
●
Wash, then dry.
your coffee hot, but the sooner you
drink it, the better it will taste.
body, filter door
●
Model CM660 After 2 hours,
●
Wipe with a damp cloth, then dry.
power to the hotplate will cease
Don't use abrasives - they'll
and the auto/on/off indicator light
scratch the plastic.
will go out.
descaling
8 When the jug's empty, switch off
You'll know when limescale has
by pressing the on/off switch
built up because your coffee will
(CM650) or the auto/on/off button
take longer to come through.
(CM660). Let the machine cool
When this happens it's time to
down before cleaning.
descale.