Playing A Pc; Connecting A Pc And Playing Its Contents - Kenwood CORE-A55 Instruction Manual

Playing a PC

Connecting a PC and playing its
contents
When a PC is connected to this system using a USB
cable (commercially available), the contents of the PC
including audio fi les and radio broadcasting can be
played by controlling the PC's software.
Prepare a USB cable (Type A – Mini B) for use in
connection of the PC to this system.
1
Connect the USB port of the PC to
the [PC IN] terminal on the rear of
the main unit using the USB cable.
USB cable (separately
available)
Turn this system OFF before connecting the PC to
it.
2
Turn the PC ON.
3
Turn this system ON.
The driver software is installed automatically in the
●
PC, which recognizes this system as "USB speaker".
Do not disconnect the USB cable while the PC is
●
detecting the connection of this system.
If the PC does not recognize this system in a few
●
seconds, try to:
- Disconnect the USB cable and connect it again.
- Reboot the PC.
24
CORE-A55/KAF-A55
4
Select the "PC" audio source.
Rotate [JOG].
Press [INPUT SELECTORA/B].
5
Control the PC software and open
an audio fi le.
The audio fi le should be selected on the PC. For the
●
operations of the PC, refer to the manuals for your PC
and the software.
The volume can be controlled on this system.
●
is displayed while the PC is connected.
●
This system is compatible with 32 kHz/44.1 kHz/48
●
kHz sampling frequencies. It can receive 16-bit
stereo/monaural data.
The PC IN terminal of this system is used exclusively
●
for input. It is not possible to record the audio played
on this system into the PC.
If the audio is not hard or very low, check the
●
Windows setup as described below.