Kenwood ICK01 User Manual page 6

With the exception of the nozzle, all
the attachments fit onto the steam
gun via a bayonet fitting: Push the
attachment onto the outlet, aligning
the groove on the attachment with
the lugs on the inside of the outlet.
Turn clockwise to lock into place.
Reverse the procedure to remove.
When using the stain removal nozzle
simply push onto the outlet, twist
slightly if necessary to locate. Pull off
to remove.
to use the attachments
1 Always ensure there is water in the
tank. Refer to the main Steam
Station instructions.
2 It is necessary to prime the
attachment before use or after a
long pause to allow any
water/condensation in the tube to be
dispensed. It's best if you don't fit an
attachment when you do this. Hold
the attachment over a suitable
container such as a jug or basin.
(Placing a cloth in the bottom of the
container will help to stop splashing).
Wait until the green ready to steam
light on the steam station glows.
Release the steam safety lock by
moving it away from the steam
button, then press the steam button
and operate the attachment until all
the water is dispersed. Take care
as a very powerful jet of hot
water or steam will be
produced. The unit is now ready to
use.
3 Select an attachment and fit onto
the steam gun.
4 Make sure the green ready to steam
light on the steam station is glowing,
then press the steam button. As
soon as the button is released steam
will stop being produced.
Important Take care not to
get burnt by steam or hot
water coming out of the
attachment.
During use you may hear a slight
G
humming coming from the steam
station this means that the pump is
operating and passing water from
the tank to the boiler where the
steam is generated. This will be
accompanied by the red water tank
indicator glowing. Wait until the
green ready to steam light glows
before continuing to steam.
IMPORTANT
Before using any of the attachments
always carry out a test run on a
small area of the material that cannot
be seen to ensure there are no
adverse effects.
to use the Fabric Care
Attachments
odour cleanser/crease
remover
This attachment has two functions:-
odour cleansing – for refreshing
G
clothing from odours and smells
such as cigarette smoke and for
refreshing garments with a deep pile
such as woollen garments as well as
delicate items such as suits or
jackets.
Place the mouth directly onto the
fabric and hold in position whilst
pressing the steam button.
crease removal – for safe removal of
G
creases from garments as well as
caring for hanging curtains without
the fear of material coming into
contact with the soleplate of a hot
iron.
Pull the material slightly with one
hand and at the same time run the
attachment down the material
pressing the steam button.
soft brush – not suitable for use
with silk and other delicate materials.
Do not confuse the soft brush with
the hard bristle brush.
3