Program Playback - Kenwood K-323 Instruction Manual

Playing a CD or audio fi le disc

Program playback

Music in a CD or audio fi le disc can be played in the
order programmed by the user.
• Select the CD source and enter stop mode.
1
Select "PGM" (program play mode).
Press [P.MODE].
Each press switches the playback mode.
CD operation
PGM
lit
Not lit
Audio fi le disc operation
N
lit
PGM
lit
Not lit
Display when the program mode is selected for a CD.
2
Select a track/ fi le.
CD operation
Select the track with [G]/[H]
or [Numeric] buttons, and press
[ENTER].
When the 7th track is selected as the fi rst track of the
program.
K-323
Program play mode
Normal play mode
Folder play mode
Program play mode
Normal play mode
20
Audio fi le disc operation
Select the folder with [G]/[H]
or [Numeric] buttons, and press
[ENTER].
Select an audio fi le with [G]/
[H] or [Numeric] buttons, and
press [ENTER].
Display when fi le 10 in folder 003 is programmed as
the 1st fi le in the program.
If you committed a mistake in selection,
press[CLEAR] on the remote control unit before
pressing [ENTER] and restart selection.
• Up to 32 fi les can be programmed.
3
Start playback.
Press [CDE].
■
To clear a track/ fi le from the program...
Stop playback and press [CLEAR] on the remote
control unit. Each press clears the last track/ fi le in
the current program.
■
To add a track/ fi le to the program after
programming...
If playback is underway, stop it and perform steps
2 and after.
■
To cancel the program mode...
Stop playback and press [P.MODE] to select the
normal play mode. The program is cleared at this
time.
• The set program is cleared when the input source is
switched, the disc is ejected or the unit is switched
OFF.