6 Push the lid onto the goblet.
7 Either push the cap into the lid, or
place the stirrer in the hole.
The stirrer can be used when
blending thick mixtures or when
large quantities of frozen items are
8 Switch on by pressing the on/off
button. Allow the ingredients to
blend until smooth.
Use the stirrer by moving it in an anti
9 Switch off by pressing the on/off
10 Place a glass under the tap, press
the on/off button and press down
on the dispensing tap lever.
Thinner drinks may dispense without
having to switch on the power unit.
Use the stirrer to assist when
dispensing thick smoothie drinks.
To help dispense the last amount of
a thick smoothie drink, add a few
tablespoons of liquid to increase the
11 When the glass is full, switch off and
release the lever.
To make a thinner smoothie drink
add more liquid.
To make a thicker smoothie drink
add more frozen ingredients.
Before fitting the lid, push the solid
ingredients into the liquid using the
Use the pulse button to operate the
power unit in a start stop action to
control the texture of your drink.
After blending, some drinks may not
be completely smooth due to seeds
or the fibrous nature of ingredients.
Some drinks may separate on
standing, therefore it's best to drink
them straight away. Separated
drinks should be stirred before
Never blend dry ingredients (eg
spices, nuts) or run the Smoothie
Blender empty - it's intended for
blending smoothie drinks only.
Don't use the blender as a storage
container. Keep it empty before and
Some liquids increase in volume and
froth during blending eg milk, so do
not overfill and ensure the lid is
To ensure long life of your Smoothie
Blender, never run it continuously for
longer than 60 seconds.
Never blend food that has formed a
solid mass during freezing, break it
up before adding to the goblet.
Always switch off, unplug and
dismantle before cleaning.
Never let the power unit, cord or
plug get wet.
Empty the goblet before unscrewing
it from the blade unit.
Always wash immediately after use.
Don't let food dry onto the goblet
assembly as this will make cleaning
Don't wash any part in the
Regularly dismantle the tap and
clean the parts thoroughly.
Before dismantling the blender, half
fill the goblet with warm water. Fit
the lid and cap then place on the
power unit. Switch on and whilst
running open the tap and allow the
water to drain into a container to
clean the valve. This can be
repeated until the water runs clear. If
further cleaning is necessary
dismantle the unit first.