Tone Setup (Ddx6054); Zone Control - Kenwood DDX6054 Instruction Manual

Tone Setup (DDX6054)

You can set a Tone curve.
1 Display the Equalizer screen
> >
Touch [ ] [ ]
2 Display the Tone Control screen
3 Set the Tone
[Bass] Bass adjustment items are displayed.
[Middle] Middle adjustment items are
displayed.
[Treble] Treble adjustment items are displayed.
[Flat] Tone level becomes 0 (flat).
[FREQ] Sets the Center frequency.
[Level] Sets the level.
[Q Factor] Sets the Q factor. (Only [Bass] and
[Middle] can be set)
[Bass DC EXT] Bass DC Extend settings. (Only
[Bass] can be set)
If turned "ON", it extends the bass center
frequency to the low register by approximately
20%.
[SW Level] Adjusts the subwoofer volume.
[Equalizer]. (page 53)

Zone Control

You can set the front and rear audio source.
1 Display the Zone Control screen
> >
Touch [ ] [ ]
2 Set the Zone Control
[Single Zone] Turns off the dual zone.
[Front Source] Sets the front audio source.
[Rear Source] Sets the rear audio source.
⁄
• When the rear speaker sound is switched, the audio
source that is output at the AV OUTPUT terminal is
also switched to the same source.
[Rear VOL.] Adjusts the volume of the rear
channel.
⁄
• There are following limitations when zone function is set
to "ON".
- There is no output from the subwoofer.
- <Equalizer Control> (page 54), <Space Enhancer> (page
56), <Position> (page 56), <DSP Bypass Control> (page
73), <Speaker Setup> (page 74), and <Car Type (DTA)
Setup> (page 75) are not available.
[Zone Control]. (page 53)
English
55