Table of Contents
Advertisement
Message
PLC setting ID on Ethernet connection
is 'PE'.
PLC setting is required before TAG
setting.
Port number is not correct.
Programmer port connection could not
be established.
Register and Device name cannot be
set on '+' line.
Register/Device is 10 character or less. In the Tag setting, more than 10 characters are used for a
Register/Device is not correct.
Register/Device is out of the allowable
range.
Runtime Error!
Program: [pass name]
R6028
-unable to initialize heap
Serial port setting is not correct.
Serial setting and PLC setting are
required before TAG setting.
Serial setting is duplicated.
Serial setting is not used for Ethernet
connection.
Serial setting is required before PLC
setting.
In the configuration file, 'PS' is used for the Ethernet
connection.
Use 'PE' for PLC setting on Ethernet connection.
In the configuration file, Tag setting is appeared before PLC
setting.
The PLC setting is required before Tag setting.
In the PLC setting, illegal port number is used.
Set the port number correctly.
Communication with the PLC using the programmer port was
failed. (Programmer port connection sequence was not
succeeded)
Check the cable and the programmer port setting in the PLC.
In the Tag setting, register/device is designated in the middle
of continuous address Tags.
Correct the setting.
register/device.
The register/device must be 10 characters or less.
In the Tag setting, invalid register/device type or invalid
address is designated.
Check the register/device.
In the Tag setting, register/device address is out of the range.
Set the register/device correctly.
Windows heap memory is not sufficient.
In the serial setting, illegal COM port setting is used.
As for the COM port, designate any of COM1 to COM4.
In the configuration file, Tag setting is appeared before serial
or PLC setting.
The serial and PLC settings are required before Tag setting.
In the configuration file, there are multiple serial settings.
Only one serial setting is allowed.
In the configuration file, serial setting is used for Ethernet
connection.
Check the setting.
In the configuration file, PLC setting is appeared before serial
setting.
The serial setting is required before PLC setting.
6. List of Error Messages
Contents
Operation Manual
33
Advertisement
Table of Contents
