Table of Contents
Advertisement
6. List of Error Messages
Message
No register/device setting.
No Serial port setting.
No Station Address setting.
No Stop bit length setting.
No TAG Name setting.
No TAG setting for the [Connection
Name].
No Timeout setting.
No Update cycle setting (High-speed/
Middle-speed/Low-speed).
No Update Cycle setting.
Only 1 Ethernet connection is allowed.
Only 1 Serial connection is allowed.
Only one PLC is available with the
programmer port connection.
PLC Name is 15 characters or less.
PLC setting ID on Ethernet must be
'PE', and PLC setting ID on serial must
be 'PS'.
PLC setting ID on serial connection is
'PS'.
32
DDE Server T-PSV
In the Tag setting, register/device is not designated.
Set the register/device.
In the serial setting, there is no COM port setting.
Set the COM port.
In the PLC setting, PLC station address is not designated.
Set the station address.
In the serial setting, there is no stop bit setting.
Set the Stop bit length, 1 or 2.
In the Tag setting, Tag name is not designated.
Set the Tag name.
In the configuration file, no Tag is designated in the
connection.
Set up the Tag.
In the connection setting, timeout is not designated.
Set the Timeout.
In the connection setting, update cycle is not designated.
Set the update cycle.
In the Tag setting, update cycle (high, middle, or low) is not
designated for a Tag.
Set the update cycle.
In the configuration file, more than one (1) Ethernet
connections are designated.
Only 1 Ethernet connection is allowed.
In the configuration file, more than one (1) serial connections
are designated.
Only 1 serial connection is allowed.
In the PLC setting, 2 or more PLCs are designated for
programmer port connection.
Only one PLC connection is allowed for the programmer port
connection.
In the PLC setting, a PLC name of more than 15 characters is
used.
Modify the PLC name within 15 characters.
In the configuration file, setting ID for PLC setting is illegal.
The PLC setting is 'PS' for Serial connection and' PE' for
Ethernet connection.
In the configuration file, 'PE' is used for the serial connection.
Use 'PS' for PLC setting on serial connection.
Contents
Advertisement
Table of Contents
