Connections; Connecting Microphones To The Xlr Input; Analog Source Recording Via The Xlr Input; Sending Analog Audio To External Analog Equipment - HHB Portadisc MDP500 Operating Instructions Manual

CONNECTIONS

CONNECTING MICROPHONES TO THE XLR INPUT

If you use a stereo microphone, connect it to the XLR
mic inputs. If you use a single microphone, connect it to
either the left or right XLR mic input. (See page 15 for
further information about recording from a microphone
and page 17 for information about mono recording.) If
you use a microphone that requires phantom power, set
phantom mode to 'ON' by accessing the INPUT menu
(see page 15).
MIC/LINE IN (L)
MIC/LINE IN (R)

ANALOG SOURCE RECORDING VIA THE XLR INPUT

MIC/LINE IN (L)
MIC/LINE IN (R)
SENDING ANALOG AUDIO TO EXTERNAL ANALOG
EQUIPMENT
LINE OUT (L)
LINE OUT (R)
CONNECTING TO DIGITAL EQUIPMENT VIA
COAXIAL OR OPTICAL
Digital source recording via COAXIAL or OPTICAL inputs.
ONE COAXIAL OR
OPTICAL CABLE
(Both inputs indicated
with arrows)
DIGITAL IN
(COAXIAL OR OPTICAL)
12
PREPARATION
PORTADISC MDP500 MiniDisc Recorder
SENDING DIGITAL AUDIO TO EXTERNAL DIGITAL
EQUIPMENT VIA COAXIAL OR OPTICAL OUTPUTS
DIGITAL OUT
(COAXIAL OR OPTICAL)
NOTE – Ensure the digital output is turned 'ON' – see
page 24 for details.
CONNECTING WITH A COMPUTER VIA THE USB
INTERFACE
MIC (L)
MIC (R)
USB

REMOTE CONTROL

The pin layout for the parallel remote connector is as
LINE OUT (L)
follows:
LINE OUT (R)
Parallel remote connector – pin configuration of Mini
DIN remote control:
LINE IN (L)
LINE IN (R)
DIGITAL OUT
(COAXIAL OR OPTICAL)
ONE COAXIAL OR
OPTICAL CABLE
(Both outputs
indicated with arrows)
(COAXIAL OR OPTICAL)
USB CABLE
cont.
DIGITAL IN
COMPUTER
USB PORT