1,
2.
3.
_'_
(,.¢_e_
C";_s_'s___¸
Disconnect
power to outlet.
Remove all contents from upper cabinet.
Place Upper Cabinet Template against the bottom of the
upper cabinet, and attach with tape or thumbtacks.
Make sure
the template centerline aligns with the vertical centerline on
the rear wall.
The "rear wall" arrows must be against the rear wall so that the
holes cut into the upper cabinet align with the holes in the top
of the microwave oven.
NOTE: If the upper cabinet has a frame around it, trim the
template edges so that it fits inside the frame, against the upper
cabinet bottom. The template has trim lines to use as guides.
4. Make sure the 83/4 '' (22.2 cm) dimension from the rear wall to
points "D" and "E" on the template is maintained.
O
5. Cut the 1W' (3.8 cm) diameter hole at the circular shaded area
"G" on the template. This hole is for the power supply cord.
NOTE: If upper cabinet is metal, the supply cord bushing needs to
be installed around the supply cord hole, as shown.
B
A. Metal cabinet
B. Power supply cord bushing
6. Drill 1/2" (13 mm) holes at points "D" and "E" on the template.
These are for two 1/4-20 x 3" bolts used to secure the
microwave oven to the upper cabinet.
For Roof Venting Installation
Only
7. Cut 3/4" (19 mm) hole at one corner of the shaded rectangular
area "F" on Upper Cabinet Template.
8. Using a keyhole saw, cut out the rectangular area.
8