Maytag MMV5156AAS Installation Instructions Manual page 12

STEP 3: Prepare The Venting Blower
4. Reassemble the blower wire. See Figure 15.
5. Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 16. When you insert blower unit,
blower wire must be like figure 16.
6. Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet. See Figure 17.
7. Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned. Attach with one blower
unit mounting screw and then one or two blower plate mounting screw(s). See Figure 18.
unit
Figure 15
ports
Figure 17
Room-Vented (Recirculating) Installation:
1. Remove one blower unit mounting screw and one or two
blower plate screw(s). Remove the blower plate from cabinet.
See Figure 19.
2. Carefully lift the blower unit out of the microwave oven.
3. Rotate blower unit 90 ° so the exhaust ports face the front of
the cabinet. See Figure 20.
4. Place blower unit back into microwave oven.
5. Reattach blower plate to microwave oven. Attach with the one
blower unit mounting screw and then the one or two blower
plate mounting screw(s). See Figure 21.
Figure 20
exhaust
ports
Figure 16
,t_--blower plate
_bl g screw
ower plate
blower uni
_./._ --!1 -back plate
"D----blower unit
blower unit mounting screw
exhaust ports
Figure 18
blower plate
unting screw
lower plate
blower unit _ II
y ",q,----blower unit
parts "B" mounting screw
Figure 19
plate
blower unit
' mounting screw
'i'_blower plate
""'h ,,,,,_----back plate
L _-,,I
blower un_
1_-----/"-,_ blower plate
mounting screw
parts "B"
Figure 21
12