Parts And Accessories - Maytag MDG6700AWM Installation Instructions Manual

Automatic dryer
Hide thumbs Also See for MDG6700AWM:
Table of Contents

Advertisement

Available languages

Available languages

ELECTRmCAL CONNECTIONS
BEFORE
OPERATING
OR TESTING°
follow all grounding
instructions
in Grounding
Section.
An individual
branch
(or separate)
circuit
serving
only this appliance
is recommended.
DO NOT USE AN
EXTENSmON
CORD.
GAS MODELS
- U,S, and Canada
A 120 volt, 60 Hz AC, approved
electrical service, with a 15 ampere fuse or circuit breaker
is required.
ELECTRIC
MODELS
-
U.S, Only
Most U.S. dryers, as manufactured,
require a 120/240 volt, 60 Hz AC approved
electrical
service.
Some
require
120/208 volt, 60 Hz approved
electrical
service.
The electric service
requirements
can be found on
the data label located on the front behind the door.
A 30 ampere fuse or circuit breaker
on both sides of the
line is required.
@
@
tf a power cord is used, the cord should
be plugged
into a 30-ampere
receptacle.
The power cord is NOT provided
with U.S. electric
model dryers.
iMPORTANT:
When
permitted
by local codes, the dryer electrical
supply
may be connected
by
means of a new power supply
cord kit, marked for use with clothes
dryer, that is U.L listed, rated at
120/240
volts minimum,
30 amperes
with three No. 10 copper wire conductors
terminated
with closed
loop terminals,
open-end
spade
lugs with turned
up ends or with tinned
leads.
Do not reuse a power supply cord from an old dryer. The power cord electric
supply
wiring must be
retained
at the dryer cabinet
with a suitable
UL listed strain relief.
tf the dryer is to be installed
in a mobile
home or an area where local codes do not permit
grounding
through
neutral,
only a 4 conductor
power cord, rated and terminated
as above, may be
used.
(Use 4-prong
plug for 4 wire receptacle,
NEMA type 14-30R)
C
LSo
A 120/240
volt, 60 Hz AC approved
electrical
service
fused through
a 30 ampere
fuse or circuit
breaker
on both sides of the line is required.
All Canadian
models
are shipped
with the power cord attached.
The power cord should
be plugged
into a 30 ampere
receptacle.
NOTE:
tt is not permissible
to convert
a dryer in Canada
to 208 volts.
REPLACEMENT
PARTS AND ACCESSORIES
tf your dryer requires
replacement
parts or accessories,
contact
the dealer from whom you
purchased
your dryer or Maytag
Customer
Service,
Box 2370, Cleveland,
Tennessee
37320-2370,
phone 423-472-3333,
for information
on the nearest authorized
Maytag
Parts Distributor.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents