PULLEY, MOTOR, DAMPER
Clean the drain pump filter
Open the lower cover cap ( ) by
using a coin. Turn the drain plug
( ) to pull out the hose.
Unplug the drain plug (
the water flows out,
At this time use a vessel
To prevent water from flowing on
the floor. If the water does not flow
any more,turn the pump filter (
open to the left.
Remove the back cover.
Take off the belt turning the pulley.
Unscrew the bolt to pull out the pulley.
Unscrew 2 screws from the bracket.
Push the motor in the arrow direction for
When reassembling the motor, make sure that motor
mounting bushings are not taken off from the bracket.
Pull out the hinge, pressing its snap.
Do not use the pulled - out hinge again. It may be
taken off during operation.
Take out any foreign material
) , then
from the pump filter (
cleaning, turn the pump filter(
clockwise and insert the
drain plug (
place. close the lower cover cap.
)to the original