Before installing, make sure that the
Bend the claws
ignition-switch is set to OFF and
remove the terminal of the car battery
to avoid short-circuiting.
Removing the existing receiver unit
If there is already an installation
sleeve for the receiver unit in the
dashboard, it must be removed.
CAR CD/MP3/WMA Receiver
Remove the existing receiver unit.
Make the necessary connections.
Install the installation sleeve.
Install the unit into the installation
Remove the rear support from the
Remove the control panel and trim
ring from the unit.
Insert the lever A into the hole on
one side of the unit.
Perform the same operation on
the other side and pull the unit out
from the mounting sleeve.
Slide the unit into the ISO-DIN
Fit screws removed from the old
Slide the unit and frame into the
Install the dash panel or adapter
Install the trim ring to the unit.
Install the control panel to the unit.