Download  Print this page

Installation - LG LWS3081ST Installation Manual

Electric convection built-in oven
Hide thumbs

Advertisement

_-_ INSTALLATION
DRAWINGS
(FOR 30"
SINGLE
BUILT-
IN OVEN)
The first step of your installation
should
be to measure your current cutout dimensions
and compare them to the
cutout dimensions
shown below. You may find little or no cabinet work will be necessary.
IMPORTANT
NOTE
• The cabinet base platform
must be able to support
1901bs (86Kg). If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom
of the cutout to support the weight
of the oven.
Make sure the base is level and front of cabinet is square. If the cabinet base is not level, the oven glides will
tend to slide out when opening the door.
• If marks, blemishes
or the cutout opening are visible above the installed
oven, it may be necessary to add wood
shims under the runners and front trim until the marks or opening
are covered.
• If the cabinet does not have a front frame and the sides are less than 3/4" (1.9 cm) thick, shim both sides equally
to establish
the cutout width.
• The junction
box must be flush with the rear wall of the cabinet as shown below.
• Allow at least 23" clearance for door depth when it is open.
27 3/8"
(69.5cm)
V--
29 5/16"
(74.5 cm)
29 3/4"
(75.5cm)
E
L<
28 7/8"
(73.3 cm)
23 3/8"
*l
(59.3 cm)
Cabinet Width
Recommended
Minimum
Cutout location
from floor
Cutout
Depth
Cutout Width
Cutout Height
30" (762 mm)
31" (787.4 m)
23 1/2" Min. (596.9 mm)
28 1/2" Min. (723.9 mm)
28 5/8" Max. (727 mm)
28 15/16" Min. (735 mm)
29" Max. (736.6 mm)
Allow 1"
minimum for
overlal
• _ _ _ Allow 1"
minimum for
23 1/2"
Minimum cutout
location from
floor 31"
Junction Box
Location
231/2"
-4-

Advertisement

Table of Contents
loading

  Related Manuals for LG LWS3081ST

This manual is also suitable for:

Lwd3081stLswd305stLsws305stLws3010stLwd3010st