HP CD-WRITER Plus User Manual page 16

16
Creating the Disaster Recovery Set
1. Click the Start button located on the Windows taskbar. Select
2. Follow the instructions on the Wizard screens to create your Disaster
For Windows 95 and Windows 98
One or more blank, formatted 1.44MB diskettes*
One or more blank HP CD-R/CD-RWs*
Windows 95/98 installation CD or install set
What is an install set? An install set is the list of files used to
install a product or operating system. Computers shipped with pre-
installed operating systems (i.e. Windows 95/98) may not include a
Windows installation CD. In this case, HP Disaster Recovery will
require your Windows install set to create the Disaster Recovery Set.
For Windows NT
Four (4) blank, formatted 1.44MB diskettes
One or more blank HP CD-R/CD-RWs*
Windows NT installation CD
*The number of diskettes and CD-R/CD-RWs required will depend on the
amount of data on your system.
To create your Disaster Recovery Set:
Programs, HP CD-Writer Plus, HP Disaster Recovery, then select
Disaster Recovery.
HP Disaster Recovery Wizard appears.
Recovery Set.
It is recommended that you label your diskettes and CD(s) when
prompted in the Wizard, and store them in a safe place. A new DR Set
should be created when new hardware or software has been added to
your system, or if many changes have been made to your files since the
last DR Set was created.
Partitioning Your Drive(s)
In the event that you must perform a recovery, HP Disaster Recovery will
require that you partition your new drive(s) to the same settings as were
Getting Started