Advertisement
Electrical connection
Electrical Shock Hazard
Turn power supply off before connecting wires.
Use 8 gauge solid copper wire.
Ebctrically ground oven.
Failure tofollow these instructions can result
in death, fire, or electrical shock.
This oven is manufactured with white
(neutral} power supply wire and a cabinet-
connected bare grounding wire twisted
together.
Make electrical connection following
u the steps needed for your installation.
1. Disconnect
the power suppJy.
2, Remove the junction
box cover.
3. Connect oven cable to junction
box
through
the U,L,-listed
conduit connector,
4. Connect the two black wires together
with
twist-on
connectors.
5. Connect the two red wires together
with
twist-on
connectors.
& Complete
electrical
connection
according
to local codes and ordinances,
ff local codes DO NOT PERMIT
connecting
cabinet-grounding
conductor to neutral white
wire in junction
box:
(Four=wire electrical system)
7. Separate the factory-crimped
bare and
white oven cane wires.
8. Connect white oven cable wire to neutral
(white) wire in junction
box. See Figure 1.
9. Connect the bare grounding
oven cable
wire to the ground wire in the junction
box. Do Not connect bare grounding
wire
to neutra_ (white) wire in iunction
box.
See Figure 1.
10. Replace junction
box cover.
cabb from
power supply
black
wires
white
and bare
grounding
oven cabte
wires
-- factory
crimped
U,L=listed
conduit
connector
.,_;_ure
2
cable from
microwave
oven
if local codes PERMIT
connecting
cabinet-grounding
conductor to neutral white
wire in junction box:
(Three-wire
electrical system)
7. Connec;t the factory-crimped
bare and
white oven cable wires to the neutral
(whitet wire in junction
box. See
Figure 2,
8. Replace junction
box cover,
Check operation
g
m Turn on power supply. The display
panel will light up briefly. "PF" should appear
in the temperature display.
m Cheek the operation of the
microwave oven.
, Fill a microwave-safe container with one cup
of water and place container inside
microwave oven. Close door firmly.
• Set microwave oven cool<time to "2:00"
minutes.
, Press the "START/ENTER" pad. The interior
microwave oven light should be on and the
remaining cooking time should be displayed.
• When display reads "1:00," open microwave
oven door. The microwave should stop
cooking.
• Close door firmly. The interior microwave
oven light should turn off.
, Press the "START/ENTER" pad. Microwave
oven should begin cooking and the
microwave oven interior light should be on.
, Let microwave oven complete cooking time.
A tone wiii sound four times at end of
cooking time and microwave oven will shut
off.
, Open microwave oven door and carefully
remove container. Water in container should
be hot.
Page 3
Advertisement
