KitchenAid KUDS30IXBL0 Installation Instructions Manual page 19

Check t hatwaterlineisontheleftsideofopening and
drainhose is near t hecenter o fthecabinet opening.
Withanother p erson holding thedishwasher to avoidit
fromtipping, o pen andclose thedoorafewtimes.Ifthe
doorcloses orfallsopenunder i tsownweight, t hedoor
tension will need to beadjusted.
Toadjust t hedoorspring tension, u nhook t hespring
fromtherearlegof dishwasher.
Using a 5/16" n utdriver o r hexsocket, remove t hescrew
fromthetensioner.
Thescrew canbeputintooneofthreeholes
lll, ll_l,lk"t
in the front leg of dishwasher. If the door closes by itself,
move the tensioner to a higher number hole and replace
screw. Reattach door spring to rear leg.
NOTE: Tensioners on both sides of dishwasher should be
secured at same holes.
When door is unlatched, and door opens by itself, move
the tensioner to a lower numbered hole and replace the
screw. Reattach door spring to rear leg.
NOTE: Tensioners on both sides of dishwasher should
be secured at same holes.
IMPORTANT: If wheels were removed, protect the floor
when moving the dishwasher. Slowly move dishwasher
completely into cabinet opening. Do not kink or pinch
water line, drain hose, power supply cord or direct wire
between dishwasher and cabinet. Remove cardboard
from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket-the blanket
reduces the sound level.
NOTE: If using power cord, make sure to route end
through hole in cutout before sliding into cabinet opening.
Align front of dishwasher door panel with front of
cabinet doors. You may need to adjust alignment to be
even with your cabinets.
19