Table of Contents
Advertisement
Sensitive
Electronic
Environment
Power Supply
Safety
Precautions
6
2
Important Safety
Information
Only use this product in countries where the relevant authori-
ties have authorised its operation.
This product complies with IP54 – according to IEC 529 /
EN 60 529.
Any radio-based equipment can potentially cause interference
with other equipment and can be interfered from other equip-
ment. This also applies for DECT equipment. However, due
to the very low transmission power level, interferences are un-
likely. Research proves that operational DECT phones nor-
mally don't influence electronic equipment. However some
precautions must be taken into account for sensitive electronic
equipment e.g. sensitive laboratory equipment. When DECT
phones operate in very close range to sensitive electronic
equipment, incidental influence can appear. You are advised
not to place the DECT phone on or close (less then 10 cm) to
this kind of equipment, even in stand-by mode.
The mains voltage of the adapter should match the local mains
voltage, this can be 110 V or 230 V. Check if both voltages do
match before installing the charger and adapter.
Please observe the following notes on safety when setting up,
connecting and using the handset:
■
Do not open the handset or charger, this could expose you
to high voltages. Have all repairs carried out by authorized
service personnel.
■
Connect to approved accessories only.
■
Do not allow the handset and charger to come into contact
with water or chemicals.
Advertisement
Table of Contents
