KitchenAid KHWS160VWH5 Installation Instructions Manual page 8

NOTE: DoNOTplug
power supplycord intooutlet.
a mConnect 1/4" (6.4 mm) spout
tubing (longer tubing) to the rear
quick-connect fitting on top of tank.
Push tubing straightinto fitting as far
as it will go, Pull on tubing. The
tubing should not come out when
properly installed,
Do Not lengthen, twist or tightly
bend tubing.
=Connect clear tubingfrom spout
to center tank tubing using clamp.
Make sure clear tubingdoes not kink.
0 • Install saddle valve following
kit instructions. I f water supply line is
not copper,shut off water supply and
drain line. Drill a 1/4" (6.4 ram) hole
into water supply line for the saddle
valve piercingpin.
1 .Turn saddle valve handle
clockwiseN until lance pierces soft
copper tubing and valve is firmly
seated. If the water line is not copper,
turn the saddle valve handle
clockwiseuntil the valve is firmly
seated. The valve is now in the
closed position.
Place a bucket under open end of
water supply line.Turn on main water
supplyvalve to pressurize cold water
line. Check for leaks.
1 2=s ow y
o_n saddle valve and
flush line into bucket to remove any
foreign material that may have been
trapped in the supply line during
saddle valve installation.
Close saddle valve.