Do NOT plug power supply cord Into outlet.
on glovesand safetyglasses.
.Determine where you will install
your hot water dispenser.Check
below sink to assure that reinforcing
ribs, supportbrackets or cabinet
constructionwill not interferewith
spout. Knock out plug from hole in
sink or cut a hole in sink or
NOTE: It Is recommended that only
a licensed plumber or professional
installer cut an opening In the sink
=Remove maskingtape and tag
from spout assembly.Do Not remove
quick-connect fittings from spout
tubing or tank tubing. Do not
brass fittings.Brass fittingscan cause
Carefully pull On/Off Cap off the
spout assembly and set aside.