KitchenAid KHWS160VWH5 Installation Instructions Manual page 4

Hot water dispenser
Table of Contents

Advertisement

codes and ordinances.
Check locationwhere hot water
dispenserwill be installed. Proper
installationis your responsibility.
Make sure you have everything
necessary for correctinstallation.It is
the responsibility of the installerto
comply with installationspecifications
and with state and local plumbing
codes.
Spout requiresa 1-1/16" (2.7 cm) to
1-3/8" (3.5 cm) diameter opening in
sink or countertop.Spout can be
installedin place of sink spray hose.
For other installations,contact a
qualified installerfor best procedure
to drill a hole through your type of
sink or countertop.Thickness of sink
or countertophole must not exceed
1-1/8" (2.9 cm).
Cold water supply connection must
be available.(See "Water supply
requirements," Page 5.)
Grounded electrical outlet is
required. (See "Electrical
requirements,"Page 5.) The outlet
shouldbe located within42"
(106.7 cm) of hot water dispenser
tank.
If spout is not to be Installed In sink
spray hose opening,contact a
qualified installer for the best
procedure for cutting a spout
opening in your type of sink or
countertop.
Plumbing connections must comply
with all sanitary, safety and plumbing
codes.
Do Not store or operate hot water
dispenser below 32°F (O°C).
Do Not usa pipe sealing compounds.
They may get inside dispenser and
cause an unpleasant taste or smell.
Water connections use quick-
connect fittings which Do Not
require seanngcompounds to keep
them from leaking.
This hot water dispenser is Not a
water purifier.Some Installations
may require a water filtering system
to Improve the quality of water.
Spout Installed In spray hose
opening In sink.
If spout Is not to be
Installed In sink spray hose
openlnn_,cut 14/16"
(2.7 cmj mln. -- 1-3/8
(3.5 cm) max. dis. sink or
countertap cutout
1-1R" (2.9 cm) max.
countertop or sink thickness
valve

Advertisement

Table of Contents
loading

This manual is also suitable for:

Khws160vwh4

Table of Contents