Overlay Series Custom Panels - KitchenAid KBFO42FSX00 Installation Instructions Manual

NOTE: All four leveling legs must contact the floor to support and
stabilize the full weight of refrigerator. Rollers are for moving
refrigerator and not for permanent support.
Use a %6" socket wrench to turn the leveling bolts clockwise to
lower the 4 leveling legs until refrigerator weight is supported by
leveling legs. The rollers should be off the floor. To avoid cabinet
damage, do not apply more than 50 inch-pounds (58 cm - kg) of
torque to the leveling legs.
A. Rear leveling legs
B. Front leveling legs
IMPORTANT:
• Install the custom handles prior to installing the panels on
the refrigerator. For more information on KitchenAid
custom handle selection, refer to the KitchenAid Catalog,
visit wvtw.kitchenaid.com, or call 1-800-422-1230.
In Canada, visit wvwv.KitchenAid.ca, or call
1-800-807-6777.
• Create custom door overlay panels according to the
specifications in the "Overlay Series Custom Panels"
section.
• KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would prevent the
refrigerator from being serviced.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator door
and freezer drawer.
2. Open the refrigerator doors and freezer drawer and remove
the trims and corner caps on each door as shown.
I ....... A
R
B ..................... .,B
I
\
A A
3. Slide the custom panels into the trims on the refrigerator door
and freezer drawer, making sure that the backer panel fits into
the hinge side trims.
A _
_oA
A. Panels
4. Reinstall the trims and corner caps.
5. Remove the protective skin from the screw covers. Snap the
screw covers into the handle trim section.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel-side down on a soft working surface.
A. Top grille
B. Cabinet side trims
A. Comer caps
B. Refrigerator door trims
C. Freezer drawer trim
16