Overlay Series ( 42"[106.7 c m]Models)
Features factory-installed,
overlay style trim, t oprovide a
"frameless" look. T his series r equires theinstallation
ofcustom
panels, handles, and standoffs.
KBFO42FTX
INSTALLATION
REQUIREMENTS
IM PC RTAN T:
•
Installer: Leave Installation Instructions with the homeowner.
•
Homeowner:
Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
•
Cordless drill
•
Torx _t T15 and T27 screwdrivers
•
Drill bits
•
1V32"Nut driver
•
Two adjustable
•
3/8",1/4",and 1/2"Open-end
wrenches
wrenches
•
Phillips screwdriver
•
5/32"Hex key
•
Small level
•
1/4"and 5/le" Socket drivers
•
Appliance dolly
•
Tape measure
•
Utility knife
PARTS NEEDED:
•
Six #8 x 3" (7.6 cm) wood screws (longer screws may be needed)
•
One or two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board(s)
•
Order factory panels, make custom panels or consult a
qualified cabinetmaker
or carpenter to make the panels.
Classic Series: Order factory panels, make custom panels, or
consult a qualified cabinetmaker
or carpenter to make the
panels. See "Installation Requirements" for more information.
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker
or carpenter to make the panels. See
"Installation Requirements" for more information.
Architect _ Series is shipped complete.
•
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
1/4"compression fitting.
I 0,11][_ 0 ]
The refrigerator can be recessed in an opening between cabinets
or installed at the end of a cabinet run using a side panel to
enclose the refrigerator.
Explosion
Hazard
Keep flammable
materials
and vapors,
such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion,
or fire.
IMPORTANT:
•
Observe all governing codes and ordinances.
•
It is recommended
that you do not install the refrigerator near
an oven, radiator, or other heat source.
•
Do not install in a location where the temperature will fall
below 55°F (13°C).
•
Floor must support the refrigerator weight, more than 600 Ibs
(272 kg), door panels and contents of the refrigerator.
•
Ceiling height must allow for side tipping radius. See "Tipping
Radius."
•
Location should permit door to open fully. See "Door Swing
Dimensions."
•
Location must permit top grille removal. See "Opening
Dimensions."
Opening
Dimensions
To avoid tipping during use, the solid soffit must be within 1"
(2.5 cm) maximum above the refrigerator. If the solid soffit is
higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the
rear wall studs 80" to 90" (203 to 229 cm) above the floor. See
"Install Anti-Tip Boards" for more information.
t®TORX
is a registered trademark
of Saturn Fasteners, Inc.
Need help?
Do you have a question about the KBFO42FTX07 and is the answer not in the manual?
Questions and answers