Advertisement
Available languages
Available languages
STOP
RIB7
\
,
\
HOSE
TABS
SPRING
CLAMP
PROVIDED
I
ON
HOSE
I
INSTALLATION
Zeve/ing
the Washer
Excessive noise and vibration
carl be prevented
by properly leveling the
washer and tightening
the leveling leg lock nuts.
1. For free standina
installation
and with the washer in it's final position,
place a level on top of the washer.
Adjust the leveling legs so the
washer is level front-to-rear
and side-to-side,
and stable corner-to-
corner.
Press down on alternate
corners and sides and feel for the
slightest movement.
Adjust the appropriate
leg so the washer is SOLID
on the floor on ALL four legs. Keep the leveling leg extension
at a
minimum
for best performance
of the washer.
Once the unit is level and
stable in it's final position,turn
the leveling leg lock nuts
against the base of the
washer and tighten
with a
wrench.
PUSH
HOSE
ONTO
- ........
COUPLER
TO STOP
RIB
z"
/
\\k
\
.
/
/
Using pliers, squeeze the ears of the spring clamp
and position the clamp so the clamp ears_
with
and contact the tabs on the drain hose. This as-
sures proper location of the clamp to prevent leaks.
ALIGN
SPRING
CLAMP
EARS WITH
TABS
ON HOSE
0_[mt
a0SE TO
_IGHT_ LEFT_ UP
0_ _C_N AS N_DED
!BEFORE_PLAOING
6[_P
I_ _$ITION
2. For pedestal
insta%tions
remove the Iocknuts from each of the
washer legs. Reinstall each leg threading
all the way into the base
(turn each leg tight to the base) before mounting
on the pedestal
See additional
installation
instructions
included with the pedestal.
3. For undercounter
installations
the Iocknuts may need to be removed
before installing.
Before installing,
verify there is enough
clearance for
the washer to be installed with the Iocknuts included.
If space is not
available,
remove the Iocknuts
from the leveling legs and
reinstall each leg by threading
all the way until tight in the
base. Remove the front
service panel and reinstall the
Iocknuts on top of the front
(2) leveling legs inside the
washer and tighten
against
the leveling leg bushings once
the unit is in it's final position.
Washer
Connections
1. Run some water from the hot and cold faucets to
flush the water lines and remove particles that might
dog up the water valve screens.
2. Remove the inlet hoses and rubber washers from
the plastic bag located in the drum of the washer
and install the rubber washers in each end of the
inlet hoses.
3. Carefully connect the inlet hose marked "HOT" to the outside "H" outlet
of the water valve. Tighten by hand, then tighten another 2/3 turn with
pliers. Carefully connect the other inlet hose to the inside "C" outlet of
the water valve. Tighten
by hand, then tighten
another
2/3 turn with
pliers. Do not crossthread
or over-tighten
these connections.
4. Connect the inlet hose ends to the HOT and COLD water faucets tightly
by hand, then tighten
another
2/3 turn with pliers. Turn the water on
and check for leaks.
NOTE:
Use only new hoses.
AL,_AYS ALIGN CLAMP _RS
_:I?N T_8
gN HQSE
Advertisement
