Figure 5-2: Mating Connector As Seen From End Of Cable - FLIR SR-100 Installation And Operation Manual

Figure 5-2: Mating connector as seen from end of cable

The following table describes the pin designations for video, power, and communications
signals.
Signal Name Pin Designation
VID OUT A
VID RTN B
Not Connected C
Not Connected D
CAM POWER E
CAM POWER RTN F
Shield G
AC LINE H
GND J
RS422 TX- K
RS422 TX+ L
RS422 RX+ M
RS422RX- N
AC NEUTRAL P
Not Connected R
Not Connected S
Table 3: SR-100P Connector pin designations
427-0014-00-10 Revision 210
Pins B, G and J are tied together for proper
ground and shield protection.
Comment
Center (core) of coax video
Coax shield
Power, Serial communications,
and Video - Tied to pin J
For enclosure heaters
Tied to pin G
Camera transmit
Camera transmit
Camera receive
Camera receive
For enclosure heaters
Copyright © 2008 FLIR Systems, Inc. 20