Telephone Base And Charger Installation; Telephone Base Installation; Charger Installation - AT&T CL82101 User Manual

Getting started

Telephone base and charger installation

Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 8 for details.

Telephone base installation

•
Plug the other end
of the telephone
line cord into a
telephone jack or
a DSL filter.
•
Raise the antenna.

Charger installation

IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Telephone line cord
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
The DSL fliter must be
plugged into the telephone
wall jack.
Plug the power adapter into a power outlet not
controlled by a wall switch.
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
5
•
Plug one end of the
telephone line cord
into the telephone jack
on the back of the
telephone base.
•
Plug the small end of
the telephone base
power adapter into the
power adapter jack
on the back of the
telephone base.
•
Route the power
adapter cord and the
telephone line cord
through this slot.
•
Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
or call
.