Final Installation Checklist - Maytag Neptune MAH5500BWW Installation Instructions Manual

FINAL INSTALLATION CHECKLIST
Instruction and Installation Kit have been removed from tub.
'_ Shipping straps have been removed.
Washer is plugged into electrical outlet and is properly grounded.
1
_' Water hoses are connected to the faucets with inlet screens and washers.
_,! Water is turned on and checked for leaks at faucet and water valve connections.
Drain hose is properly located into drain facility and is not collapsed or damaged.
Washer has been properly leveled. All legs should be firmly on the floor and leveling leg lock nuts
MUST be tightened.
i-! Washer fills properly on all temperature selections.
Test for proper operation by running the washer through a complete cycle.
MAH5500B
1, Press "Cotton/Sturdy" to turn the machine on,
2. Arrow up to select "Hot/Cold" wash/rinse temperature.
3, Press "StartJPause",
4. Verify the washer is filling with hot water.
5. Verity the washer stops filling.
6. Press "Start/Pause" to pause the cycle,
7. Select "Rinse"; press "Start/Pause" to resume the cycle,
8. Verify the washer is filling with cold water,
9. Verify the washer stops filling.
10. Press "Start/Pause" again; select "Spin"; press "Start/Pause" to resume the cycle.
11, Verify the washer spins. This will take several minutes, the machine wilt first drain and distribute the clothes.
12. Pull on the door to make sure that it has tocked.
13, Allow the cycle to finish, verify that the door has unlocked at the end of the cycle.
MAH750_____0
1. Press "Home"; select "Cotton!Sturdy'_; "Hot Wash/Cold" Rinse'L
2. Press "Start/Pause".
3, Verify the washer is filling with hot water.
4, Verify the washer stops filling,
5, Press "Start/Pause'.
6. Press "Off",
7, Press "Home"; select "More Cycles" then select "Cold Rinse & Spin"; press "Start/Pause" to resume the cycle,
8, Verify the washer is filling with cold water.
9, Verify the washer stops filling.
10, Press "Start/Pause".
11. Press "Off".
12, Press "Home"; select "More Cycles", then select "Spin"; press "Start/Pause" to resume the cycle,
13. Verify the washer spins. This will take several minutes, the machine will first drain and distribute the clothes,
14. Pull on the door to make sure it has locked,
15. Allow the cycle to finish, verify that the door has unlocked at the end of the cycle.
Make any corrections necessary to properly complete the installation.
Page 4